Good morning! I just received the pushrods and can’t wait to try them out. I loved the little gift you included!
One of my lifters/lifter guide failed. Unfortunately, it wasn’t stuck. When I put my little camera in the hole I saw where it was turned. Anyway, that means everything must be done. When I removed the pushrods two of them were bent (same cylinder as the failed lifter). I just assumed I might as well replaced the rocker arms with the upgraded trunions to go with your pushrods. Any recommendations? Should I swap the springs too while I’m at it?
Good morning! Do you have any dod deletes or timing videos of you dropping the oil pan for the Gen V engine? I’ve mostly only seen your video where you loosened some things in order to barely get the camshaft out. Since this will be my first job dealing with timing, I want to take the best route even if it means adding more steps to the process. I’ve watched other people’s videos when searching for timing, chain replacement, oil pump replacement, etc but would like to see if you have one since you tend to be more detailed.