For a 2007 sierra 5.3 L, In the videos and VLOM mod instructions it shows tapping the VLOM plug into the oil pressure sensor port til it bottoms out. Is it a problem if the plug did not require tapping with hammer but instead could pushed into place by pushing on a socket with fingers. It seems to be a snug fit, but not tight enough to require tapping with hammer. I am having the computer delete done and have cut the gaskets in the VLOM.
top of page
Automotive Vehicle Repair & Performance Shop
AFM and DFM specialist!
USA Company Located SE SOUTH DAKOTA
bottom of page
That's perfectly fine. As long as it has some resistance. I'm assuming you have the one with a slot? The slot units at the time of this response are intended for the Lt based (2014+) and ones without slot are for that LS based. They are the same size but the slot is needed in the Lt because it has a smaller stepped hole and plug needs to squeeze down more.