Good morning! I just received the pushrods and can’t wait to try them out. I loved the little gift you included!
One of my lifters/lifter guide failed. Unfortunately, it wasn’t stuck. When I put my little camera in the hole I saw where it was turned. Anyway, that means everything must be done. When I removed the pushrods two of them were bent (same cylinder as the failed lifter). I just assumed I might as well replaced the rocker arms with the upgraded trunions to go with your pushrods. Any recommendations? Should I swap the springs too while I’m at it?
Unfortunately I had already bought the kit from Texas speed several months ago the ago :(.
So I got the heads off today and officially confirmed my diagnosis (after being educated by Crazed Performance University haha). Why are the lifter guides made of plastic? I thought surely someone out there would have made an upgraded guide out of metal but none found so I take it there’s a reason behind the engineers designing them that way?
Next question, I think I saw on one of your videos that you make the stuck lifter tool out of pushrods. Since I am upgrading my pushrods to yours, do you want my old lifters?