I have my 2012 Silverado tore down to do the delete kit. #1 lifter was the culprit. This lifter is stuck in the hole. I have all the other lifters out. Looked through one of the openings and can see the roller end is smashed. Any advice on getting it out?
top of page
Automotive Vehicle Repair & Performance Shop
USA Company Located SE SOUTH DAKOTA
Merry Christmas!!
You May Experience Weather Delays During the Hoilday Season!
We will be Closed Dec. 24th & Dec. 25th for Christmas!
Please respect any delays.
bottom of page
Got the delete finished. The noise is gone. Still has a constant p0301 and sometimes a p0300, cyl 1 was the cylinder that collapsed
Got it out through the camshaft opening. Luckily it cylinder 1 not 7 Lol. Initial inspection I don't see or feel any gouges but will take a closer look
Lol, hate to rely on it too much but... Good luck! Best bet is to grab an engine from the yard if you can find one. Then delete it.
I know how my luck goes, so does anyone know where I can get decently priced used short block?
Ouch, you may have to pull the cam and try to push it out the camshaft side. Last one I had like that was the rollers pin had slid out and it wrecked the aluminum block. Hopefully that's not the case here.